Part #1: Setting up the Machine

1. Important! Remove the front panel (below the switch panel) by unscrewing the six screws on the sides. Replace the Red Shipping Plug with the Yellow Dip Stick included in the parts box. The Yellow Dip Stick has vents in it that allows the pump to breathe air. Failure to do so will void pump warranty on the pump. (for additional details on this, read section 4.2 page 3 of your operational manual)
2. Connect the garden hose to a cold water outlet/faucet and the other to the machine
3. Connect extension cord (Hi Amp and no longer than 50 ft.) to electrical outlet and the machine
4. Connect steam hose to machine
5. Make sure ON/OFF ball valve on wan is in open position
6. Connect regulator to LP tank and machine and open silver valve on tank by turning it counter-clockwise

Part #2: Turning the Steam Cleaner on

1. Let the water glow through the machine for at least 2 minutes before turning any switches on. This gets rid of the air in the heat coils.
2. Turn the pump switch "ON". Wait 30 seconds before next step
3. Turn the ignition switch "ON" and reduce gas to 1-2 PSI on the fuel pressure gauge by turning the "red" regulator knob.
4. Never start the machine at a fuel setting above 4 PSI on the gauge
5. If machine does not light within 15 seconds turn the ignition switch "OFF" and immediately back "ON". Continue this process until the machine fires up.

Part#3: Setting the Temperature on the Steam Cleaner

1. If you are going to clean floors use the small silver :FAN NOZZLE". This nozzle has a wide spray. It cleans best at 220-250 degrees F.
2. If you are cleaning items that are burned on use the brass "JET NOZZLE". This nozzle has narrow spray. It cleans best at 270-300 degrees F.
3. When the machine comes on you will be at fuel setting of 1-2 PSI. Allow the temperature to rise until it stabilizes.
4. If it stops below the desired temperature increases the gas flow by no more than ½ PSI at a time by turning the "red knob" clockwise.
5. Continue to do this until the desired temperature is reached.

Part#4: Locking in the Temperature

1. Once the machine stabilizes at the desired temperatures (usually 240-250 degrees), you can lock this gas setting.
2. You will see a nut under the "red" regulator knob.
3. Screw this nut down by hand until it tightens against the base of the regulator.
4. If you always use the same intake water temperature you will now be able to reach the desired temperature without touching the red knob.

Part#5: Turning the Steam Cleaner Off

• First turn the ignition switch "OFF". Leave the pump switch "ON" for now.
• Close the "silver" knob on the LP gas bottle by turning it clockwise.
• Leave the pump "ON" until the steam hose cools down.
• Turn the pump switch "OFF" and turn the faucet "OFF"
• You can now disconnect the hoses and the extension cord.

>>> Things you need to know when using the Steam Cleaner